Probe View
Carry out a probe of the modules attached to a harness.
This returns a series of letters representing the signal from each RX channel on the harness:
0 means there was no signal 1 means there were only 1's 2 means there was a CLK/2 signal E means there was the beginning of a valid event (11101) J means any other signal
(The following should only occur when a trigger is sent to a loop back device)
L means there was one L1A (110) S means there was one Soft reset (1010100) B means there was one BC reset (1010010)
ROD Diagnostics
From here, MDSP memory blocks can be examined and single words can be editied.
The bottom line can be used to send the digital signal from the BOC directly to the LEMO connector on the ROD front panel.
DDC Diagnostics
From here a hard reset or state change can be performed on any crate or channel in the DCS system.
Scan View
From here any previous scan request can be viewed, edited, deleted or resent (this will confuse the CalibrationController!).